P1074464_wt.7z Page

: This is the standard method where you select a "neutral plane" that determines the pull direction. The draft angle is then applied to the faces you select, pivoting them from that plane.

: For extremely difficult geometry, copy the surfaces, apply the draft to those surfaces, trim them, and then "Solidify" them back into the main part. p1074464_wt.7z

: Often used for more complex geometry, this method allows you to use a specific edge or curve as the split point for the draft. This is highly recommended for parts with non-planar divisions. : This is the standard method where you

: If a face is too complex, use a "Split Line" to break it into smaller segments before applying the draft to each part individually. copy the surfaces