Nad Phono Preamp Pp2 Manual -

Plug your turntable's RCA leads into the or MM inputs on the back of the PP 2, depending on your cartridge type. Match the colors: Red for Right (R) and White for Left (L).

The PP 2 utilizes high-quality components and a 24V power supply for enhanced musical dynamics and stability. Moving Magnet (MM) Moving Coil (MC) Gain at 1kHz Input Sensitivity 3.5mV (ref. 200mV output) 0.2mV (ref. 200mV output) Signal-to-Noise Ratio 80dB (A-weighted) 78dB (A-weighted) RIAA Accuracy ±0.3dBplus or minus 0.3 d cap B ±0.3dBplus or minus 0.3 d cap B THD (20Hz - 20kHz) Source: NAD PP-2 Specifications . 3. Troubleshooting Nad Phono Preamp Pp2 Manual

: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver. Plug your turntable's RCA leads into the or

If you encounter issues, refer to the following common solutions: : Moving Magnet (MM) Moving Coil (MC) Gain at

: Connect the external 24V power supply to the PP 2 and plug it into a wall outlet. A green LED on the front panel indicates the unit is powered. 2. Technical Specifications

: Toggle the rear MM/MC switch to match the input you used.

Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz :