Kk2.jpg Official

: Use the on-board "PI Editor" to adjust the gain settings if your drone feels shaky or sluggish. Beginners can often start with the default firmware settings provided by DroneTrest. KK2.1 Flight Controller Guide - Guides

: Wait for the ESCs to emit a short beep (full throttle signal), then immediately lower the transmitter throttle to idle. kk2.jpg

This step ensures all motors start at the same time and respond equally to your throttle: : Ensure propellers are OFF . : Use the on-board "PI Editor" to adjust

: To prepare the motors for flight, move the throttle to zero and the rudder stick to the far right . A red LED or an "Armed" message on the screen will appear. This step ensures all motors start at the

: Connect your Electronic Speed Controllers (ESCs) to the right side of the board. Ensure you use the correct motor layout for your frame type (e.g., Quadcopter X or +).

: Use the "Subtrim" function on your transmitter to ensure all values (except throttle) show ZERO when the sticks are centered. 3. ESC Calibration