In Proteus ISIS 7.7, "generating a piece" typically refers to that isn't already in the standard library. Step-by-Step: Generating a New Component Follow these steps to create a custom schematic part: Draw the Component Body :
Click and drag on the schematic sheet to draw the shape of your component. : Select Component Pin Mode (the icon with a dot and a line).
Use the to draw a box around your entire drawing (box and pins). Right-click the selection and choose Make Device . Configure Device Properties : isis-proteus-7-7
: Click Next to link a PCB footprint (from ARES) if you plan to design a board later. Save to Library :
Click the icon (blue square) in the left toolbar. In Proteus ISIS 7
Place pins on the edges of your 2D box. You can rotate them (using the keypad + or - ) so the connection point faces outward. : Double-click each pin to open the Edit Pin dialog.
Click to finish. Your new "piece" will now appear when you search the library with the Pick from Library (P) button. Alternative Methods Use the to draw a box around your
Enter a (e.g., VCC, GND) and a Pin Number that matches the physical footprint. Create the Device :