Close

Search the Site

MENU

Delta 52 611 Sander Manual (Hot × 2024)

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine

Maintain a minimum clearance of between the table and the sanding belt for safety. Delta 52 611 Sander Manual

: Overall height of 60", weighing roughly 200 lbs.

: Tilts 45° out (away from belt) and 20° in (toward belt). : Must be secured to a workbench or

: Clean unpainted surfaces (like the table) with a cloth moistened with kerosene to remove protective coatings. Table Assembly :

Insert the support rod into the base and tighten the socket head screw. Ensure the gauge is heavy enough to prevent

Slide the table assembly onto the rod and secure it with the secondary socket head screw.

: Must be secured to a workbench or floor; if using a workbench, drill four 3/8-inch holes to permanently bolt the base. 2. Setup and Installation

: Use a 3-wire grounded extension cord. Ensure the gauge is heavy enough to prevent voltage drops and overheating (refer to the Delta Abrasive Belt Manual for specific gauge charts). 3. Operational Safety 6" Abrasive Belt Finishing Machine

Maintain a minimum clearance of between the table and the sanding belt for safety.

: Overall height of 60", weighing roughly 200 lbs.

: Tilts 45° out (away from belt) and 20° in (toward belt).

: Clean unpainted surfaces (like the table) with a cloth moistened with kerosene to remove protective coatings. Table Assembly :

Insert the support rod into the base and tighten the socket head screw.

Slide the table assembly onto the rod and secure it with the secondary socket head screw.