If the door uses a pneumatic seal (bottom gasket), ensure a solid floor surface is available; without a floor or obstruction, the machine cannot calibrate the stop position. 3. Programming Procedure ("Programming the Road")
The following steps are standard for calibrating the CDM9 drive using the internal : CDM9з”µжњєзљ„зј–зЁ‹пј€VLпј‰.mov
Manually move the door to a height of approximately 100 cm above the floor. If the door uses a pneumatic seal (bottom
Before initiating the "programming the road" sequence, ensure: without a floor or obstruction
The CDM9 is a specialized automation drive designed for overhead sectional doors. The "VL" designation refers to track configurations, where the door travels straight up the wall. Proper programming is essential to define "the road"—the specific travel distance and resistance parameters for the motor. 2. Pre-Programming Checklist
The gate/door should be approximately 150 cm from the floor.