Ajb0003 Mp4 (2027)

You can add a taper angle directly inside the Extruded Boss/Base feature rather than as a separate, later step. Advantages and Best Practices

The most common method. You select a plane (e.g., top face) to act as the fixed reference, then select the faces to taper. Ajb0003 mp4

Are you dealing with a (a line dividing two halves of a mold)? Is the part a simple block or a complex curved surface ? You can add a taper angle directly inside

You can apply drafts to multiple faces at once, reverse the direction, or change the angle after the part is modeled. reverse the direction

To help me narrow down the best way to apply a draft, could you tell me: